Now, your E-Mail address is required to leave your message. Your E-Mail address could be traceable by the Web Master in the even of virus, spy ware, obscene messages attacks.

Looking for Sansui Brochures, Bulletins, or Manuals (manuals include schematics)?  Or, need NOS parts?  Visit OBS, Inc Site,  Site, or  Go back to the Best of Sansui

Re: AU-9500 Voltage problem

[ Follow Ups ] [ Post Followup ] [ BBS_General ] [ FAQ ]

Posted by Sten on October 31, 2004 at 04:19:00:

In Reply to: Re: AU-9500 Voltage problem posted by Ken on October 31, 2004 at 02:20:41:

It seems that you have a Japan Model without Voltage Selector. In such a case the Power Transformer only work at a fix Voltage. You need a multi Voltage Transformer to solve the problem.

: My rear panel's small plate was flat and not the the picture there which seems a small box was built upon...

: : Hi Ken
: : Visit and check if your AU-9500 real panel is similar.

: : : That was the plate stated the voltage used?
: : : i had open that small cover that I saw nothing inside.... Was my amp was a handicap one?

: : : : Hi Ken
: : : : Donīt you have a Voltage Selector located at rear panel. Itīs hided under a cover where you can see Sansui Logo and Model Name of the amp. Two screws to be removed.

: : : :
: : : : : Recently I got an AU-9500 from E-Bay which suprise me that was a 110V machine (shown in the back). But in the tech spec on this web, AU-9500 should be an 110-240 auto voltage machine. My country was using 220V power, any one can help to change the input accept to 220V????

Follow Ups:

Post a Followup




Optional Link URL:
Link Title:
Optional Image URL:

[ Follow Ups ] [ Post Followup ] [ BBS_General ] [ FAQ ]