AU-717 with a dead channel

[ Follow Ups ] [ Post Followup ] [ The Best of Sansui ] [ FAQ ]

Posted by Jim Roffey on November 08, 2003 at 18:45:04:

I have an AU-717 that I bough new back in '77. It has always been very dependable until I just took it out of storage where it has been for the past 8 years (in my basement). I plugged in a new disc changer (into the aux input) and only one of the speaker channels worked. I checked the original literature and there was a blurb on quick change fuses which could be the cause. After pulling off all the panels except the base I finally found two fuses (behind the base panel) and they were both good as I checked them for continuity. I did get a fleeting bit of music from the channel but I could not repeat it. Please does anyone have any advice or is it even worth persuing?? Thanks in advance Jim Roffey

Follow Ups:

Post a Followup




Optional Link URL:
Link Title:
Optional Image URL:

[ Follow Ups ] [ Post Followup ] [ The Best of Sansui ] [ FAQ ]